one.A connecting website link of an O-ring Chain for common application is pre-coated with grease in the pins. Before connection, verify the grease within the surfaces of pins, and should the amount of grease is tiny, apply grease with bare hands. (If gloves are used, the grease will likely be absorbed by the gloves.)
Example: Once the connecting hyperlink (I) of an O-ring chain for common application is
shipped, O-rings are fitted in the roots on the pins. In case the O-rings come loose due to vibration in the course of transport, refit the O-rings in to your roots of the pins.
In this instance, be sure to return the grease collected at the roots on the pins to your central surfaces of your pins, more at portion A than at portions B shown within the over illustration. (Portions A is worn because of sliding using the bushings.)
two.The chain may be most easily linked within the teeth of the sprocket. Engage the backlinks at each ends with the chain using the sprocket teeth and fit connecting pins. In the event the sprocket can be moved, the chain can also be connected about the loosened side.
three. Connecting method
one.Confirm that O-rings are attached to the roots of your pins.
two.In case the volume of grease utilized about the connecting pins is compact, coat the pins with grease at the central portions.
3.Insert the connecting pins to the bushings in the inner links at the two ends.
4.Confirm the grease is applied on the whole face of your O-ring, and fit the O-ring onto the connecting pins.
five.Insert the connecting pins in to the connecting plate and though pressing the connecting plate, set up the spring clip. Confirm no matter if the head (the end without a split) of your spring clip is turned within the feeding route with the chain. (See the following illustration.)
six.Make sure to verify the spring clip is securely fitted in the clip grooves of the connecting pins.
This completes jointing with the connecting link. Note that grease around the surfaces of connecting pins and O-rings could be removed through set up do the job. In this instance, re-grease using the grease about the surface on the base chain or even the grease inside the polyethylene bag during which the connecting hyperlink was contained.