The EP Greenhouse gear motor is a concise and lightweight reduction reducer with a limit switch system that is ideal for assembly of a locally available electric engine. The gear motor is utilized in manually-managed or climate-controlled ventilation and display systems in greenhouses. The quick and easy-to-install EP geared motor is rainproof and windproof. The gear reducer includes a high protection class (IP65) and can be utilized within an ambient temperature of 0-60 °C.

The low-noise gear reducer for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel tranny ensures that the drive shaft is usually locked when the reduction gear reducer isn’t running. The completely sealed reduction gear reducer comes with an growth chamber with a diaphragm to keep carefully the gear oil at a low pressure under all conditions, even at high temperature ranges. Thanks to the use of an expansion chamber, the gear reducer can be installed in any placement. There are no restrictions, since there is no dependence on a bleed plug. The sealed reduction gear motor keeps the gear essential oil of the gear reducer in ideal condition because of its entire operating life time. The gearbox is suitable for discontinuous use, operating course s3-30%, with a maximum activation period of 25 minutes.

The Gear box reduction gear motor comes with an FT85 motor assembly flange, to which the right IEC standard motor can simply be installed (EN 50347).

The Gear box includes a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off by the end positions. The limit switch system is installed within an included chamber and is definitely enclosed by an impact-resistant plastic-type material cover. The limit change system is obtainable and simple to adjust. The limit switch system’s optimum switching range can be 40 or 64 revolutions of the drive shaft. The cabling is connected in spring-clip connections. The gear motor comes with an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.

The geared motor for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates can be found as accessories.

Maximum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in the event of software of 4-pole electric motor.
Protection class IP65.
Can be used in ambient temperature ranges of 0-60°C.
Ideal for discontinuous use, operating class s3-30%, optimum activation time 25 mins.
Equipped as regular with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installing IEC standard motor (EN 50347).
Maximum switching selection of limit switch system 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).