Power UNITS FOR LIFT TABLE 1
Basic Description
This energy unit is designed exclusively for that compact lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, etc. This electrical power unit is broadly applied from the sector of logistic units for instance minifork lift, scissors lift and ariel working platforms. The lower-ing motion is managed through the solenoid valve with all the velocity managed by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
General Description
This electrical power unit is made exclusively for that medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve plus the pace managed by the adjustable needle valve. When the lift rises to a higher positoin, but the energy supply is reduce, the decreasing movement is managed through the guide override perform.
Electrical power UNITS FOR LIFT TABLE 3
General Description
This power unit is created exclusively to the significant lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve as well as pace controlled by a stress compensated flow control valve.
Energy UNITS FOR LIFT TABLE four
Basic Description
This power unit is designed exclusively for the large lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve as well as pace managed by the adjustable needle valve. When the lift rises to a substantial positoin, but the energy provide is lower, the lowering movement is managed from the manual override perform.
Unique Notes
1. This power unit is of S3 duty cycle, which can only do the job intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean each of the hydraulic parts concerned before set up of the power unit.
three. Viscosity of your oil shoud be 15~46 cst,which must also be clean and free of impurities.N46 hydraulic oil is recommended.
four. Oil altering is required immediately after the initial one hundred operation hrs,afterwards after just about every 3000 hrs.
5. The energy unit proven is built to be mounted vertically.